Stop mixing coolant by hand.

Hydroblend proportioners are made by Hydroblend International (hydroblend.com) - that is the maker's site. This page is the dedicated version for UK CNC machining shops, by their official EU partner.

The Hydroblend mixing cabinet screws to the wall by any tap. No motor, no wiring, nothing to PAT test. Dial the mix once and every fill and top-up comes out at the right strength - under 1% deviation, whatever your water pressure does.

£1,990 deliveredEU stock, 1-week delivery · CE marked · 30-day money-back guarantee

Check your coolant is compatible - free

Hydroblend proportioner inside the turn-key mixing cabinet: water meter, filter and stainless-and-acrylic proportioner, pre-plumbed

What hand-mixing actually costs

Concentrate

Nobody hand-mixes lean - the jug runs 2-3 points rich, because rich never gets anyone shouted at. Every point rich burns concentrate on every fill, week after week.

Setter time

Walk to the barrel, wait for the bucket to fill, walk back - on £20 an hour, every single fill. The hose on the wall ends the bucket run for good.

Skin - and people

Too-rich emulsion is harsher on skin. Dermatitis is how shops lose good operators - and replacing one costs thousands of pounds.

Locked with a key. On purpose.

On an open on-barrel mixer, one operator sets the ratio higher once - and it silently over-riches every machine from then on. Total loss of top-up control.

The Hydroblend proportioner sits inside a painted-steel cabinet, locked with a key. Controlled access: the ratio stays where you set it, on nights, on weekends, whoever is filling.

Water-driven - runs off tap pressure alone
Proportioner in stainless steel and acrylic, fully rebuildable
Set-and-repeat graduated scale, lockable
Built by the same family firm since 1974 - it just runs and runs

Hydroblend graduated scale set - set-and-repeat dilution setting

Hydroblend cabinet installed above a Henkel Bonderite concentrate barrel in a real workshop

One ladder, three rungs

The same Hydroblend proportioner works three ways - how far you take it depends on your shop:

The cabinet + roll-up hose. Pull it out, fill the sump, roll it back. No buckets, no carrying, right mix every time. Where every shop starts.
One-directional central. One mixing point, permanent drop lines at every machine. Lower top-up concentration, same mix on every shift.
The full closed loop - Filco Masterclean. Central mixing, distribution and emulsion treatment in one system, with Hydroblend as its mixing part - delivered with our Danish partner Filco. One place for cutting-fluid management, forget individual tanks.

Nothing is thrown away between rungs - the cabinet you buy today becomes the mixing point of the system you grow into.

Straight answers

What's in the box?

Hydroblend 6080-A-V proportioner, water filter, water meter and bypass valve - pre-plumbed in a lockable cabinet. Fitting it is a plumbing job at an ordinary tap. No electrician, because there are no electrics.

Will it work with my coolant?

Most leading cutting-fluid brands are already validated. Tell us what you run and we confirm it - or test it free before you buy.

What if it doesn't earn its keep?

30-day money-back from delivery. Send it back, no forms, no arguing. It ships from EU stock - one week to your door.

£1,990 delivered EU stock, 1-week delivery 30-day money-back CE marked Free compatibility testing

Email us - one line does it Prefer to call? +372 5857 5065